Installing The Hot-Swap Hard Disk Drive Backplane - IBM System x3100 M4 Type 2582 Problem Determination And Service Manual

11. Lift the hot-swap backplane out of the lower lip on the drive cage and set it
12. If you are instructed to return the SAS/SATA hard disk drive backplane, follow

Installing the hot-swap hard disk drive backplane

This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
To install the hard disk drive backplane on the 5U server model with hot-swap
power supplies (Model name: 2582-F4x), complete the following steps.
224
IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
Screws
aside.
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
1. Place the bottom edge of the hot-swap hard disk drive backplane in the lower
lip of the drive cage.
2. Connect the power, signal and configuration cables to the hard disk drive
backplane.
Note: Make sure that Port 1 on the hardware ServeRAID is connected to Port
1 on the backplane. Likewise, Port 0 on the hardware ServeRAID should be
connected to Port 0 on the backplane.