IBM System x3100 M4 Type 2582 Problem Determination And Service Manual page 284

To install the system board on the 5U server model with hot-swap power supplies
(Model name: 2582-F4x), complete the following steps. For 4U server models with
non-hot-swap power supplies, please see the above sub-section.
264
IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 163.
2. Touch the static-protective package that contains the system board to any
unpainted metal surface on the server. Then, remove the system board from
the package.
3. Insert the system board into the chassis and slide it toward the rear of the
server until the screw holes on the system board align with the screw holes on
the chassis.
System board
(7 screws)
4. Install the seven screws that secure the system board to the chassis.
5. Install any of the following components that you removed from the system
board:
v Adapters (see "Installing a ServeRAID adapter" on page 178).
v Battery (see "Installing the system battery" on page 209).
v DIMMs (see "Installing a memory module" on page 203).
v Microprocessor and heat sink (see "Installing a microprocessor and heat
sink" on page 254).
6. Reconnect any cables to the system board that you disconnected during
removal (see "System-board internal connectors" on page 17).
7. Secure the cables with the retention-clips.