IBM System x3100 M4 Type 2582 Problem Determination And Service Manual page 98

Type 2582
Hide thumbs Also See for System x3100 M4 Type 2582:
Table of Contents

Advertisement

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
4000007d-
Power cap and external
00000000
throttling occurred.
4000007e-
External throttling
00000000
occurred.
4000007f-00000000 Power cap throttling
occurred.
40000080-
Remote Control session
00000000
started by user [arg1] in
[arg2] mode.
40000081-
PXE boot requested by
00000000
user [arg1].
40000082-
The measured power
00000000
value has returned
below the power cap
value.
40000083-
The new minimum
00000000
power cap value has
returned below the
power cap value.
40000084-
IMM firmware mismatch
00000000
between nodes [arg1]
and [arg2]. Please
attempt to flash the
IMM firmware to the
same level on all
nodes.
40000085-
FPGA firmware
00000000
mismatch between
nodes [arg1] and [arg2].
Please attempt to flash
the FPGA firmware to
the same level on all
nodes.
40000086-
Test Call Home
00000000
Generated by user
[arg1].
40000087-
Manual Call Home by
00000000
user [arg1]: [arg2].
40000088-
Management Controller
00000000
[arg1]: Configuration
restoration from a file
by user [arg2]
completed.
78
IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
Info
Power cap and
external throttling
occurred.
Info
External throttling
occurred.
Info
Power cap
throttling occurred.
Info
Remote Control
session started
Info
PXE boot
requested.
Info
Power exceeded
cap recovered.
Info
Minimum Power
Cap exceeds
Power Cap
recovered
Info
A mismatch of
IMM firmware has
been detected
between nodes.
Error
A mismatch of
FPGA firmware
has been detected
between nodes.
Info
Test Call Home
generated by user.
Info
Manual Call Home
by user.
Info
This message is
for the use case
where a user
restores a
Management
Controller
configuration from
a file and it
completes.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents