IBM System x3100 M4 Type 2582 Problem Determination And Service Manual page 311

Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName <m/t_model>
--user <IMM2_user_id> --password <IMM2_password>
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum <s/n> --user <IMM2_user_id>
--password <IMM2_password>
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag <asset_tag>
--user <IMM2_user_id> --password <IMM2_password>
Examples that do use the userid and password default values:
asu set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
asu set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
asu set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
v Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this
access method.
The KCS access method uses the IPMI/KCS interface. This method requires
that the IPMI driver be installed. Some operating systems have the IPMI
driver installed by default. ASU provides the corresponding mapping layer.
See the Advanced Settings Utility Users Guide for more details.
The following commands are examples of using the userid and password
default values and not using the default values:
Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName <m/t_model>
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum <s/n>
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag <asset_tag>
v Remote LAN access, type the command:
Note: When using the remote LAN access method to access IMM2 using the
LAN from a client, the host and the IMM2_external_ip address are required
parameters.
host <IMM2_external_ip> [user <IMM2_user_id>[[password
<IMM2_password>]
Where:
IMM2_external_ip
The external IMM2 LAN IP address. There is no default value. This
parameter is required.
IMM2_user_id
The IMM2 account (1 of 12 accounts). The default value is USERID.
IMM2_password
The IMM2 account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
The following commands are examples of using the userid and password
default values and not using the default values:
Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName <m/t_model> --host <IMM2_ip>
--user <IMM2_user_id> --password <IMM2_password>
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum <s/n> --host <IMM2_ip>
--user <IMM2_user_id> --password <IMM2_password>
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag <asset_tag>
--host <IMM2_ip> --user <IMM2_user_id> --password <IMM2_password>
Chapter 6. Configuration information and instructions
291