Installing The Hard Disk Drive Fan Duct - IBM System x3100 M4 Type 2582 Problem Determination And Service Manual

6. If you are instructed to return the fan, follow all packaging instructions, and use

Installing the hard disk drive fan duct

This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
Attention:
v To ensure proper cooling and airflow, do not operate the server for more than 30
To install the hard disk drive fan duct on the 5U server model with hot-swap power
supplies (Model name: 2582-F4x), complete the following steps.
1. Unlock and remove the side cover (see "Removing the side cover" on page
2. Carefully turn the server on its side so that it is lying flat, with the system board
3. Lower the hard disk drive fan duct into the chassis, making sure the two guide
Hard disk drive
fan duct
Guide pins
any packaging materials for shipping that are supplied to you.
minutes with the side cover removed.
166).
facing up.
Attention: Do not allow the server to fall over.
pins and two latches on the chassis protrude through the respective holes on
the hard disk drive fan duct.
Latch holes
Latches
Chapter 5. Removing and replacing server components
215