Installing The System Battery - IBM System x3100 M4 Type 2582 Problem Determination And Service Manual

6. Locate the battery on the system board (see "System-board internal connectors"
7. Remove the battery:
To remove the battery on the 5U server models with hot-swap power supplies
(Model name: 2582-F4x), complete the following steps. For 4U server models with
non-hot-swap power supplies, please see the above sub-section.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the side cover" on page
4. Carefully turn the server on its side so that it is lying flat, with the system board
5. Locate the battery on the system board (see "System-board internal connectors"
6. Remove the battery:

Installing the system battery

The following notes describe information that you must consider when you replace
the battery in the server.
v You must replace the battery with a lithium battery of the same type from the
v To order replacement batteries, call 1-800-426-7378 within the United States, and
on page 17).
a. Use one finger to tilt the battery horizontally out of its socket, pushing it
away from the socket.
b. Lift and remove the battery from the socket.
on page 163.
and external cables.
166).
facing up.
Attention: Do not allow the server to fall over.
on page 17).
a. Use one finger to tilt the battery horizontally out of its socket, pushing it
away from the socket.
b. Lift and remove the battery from the socket.
same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM marketing representative or authorized reseller.
Chapter 5. Removing and replacing server components
209