IBM System x3100 M4 Type 2582 Problem Determination And Service Manual page 76

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f0021-2582xxxx PCI fault has been
detected for One of PCI
Error or All PCI Error.
806f0413-2582xxxx A PCI PERR has
occurred on system
%1.
(%1 =
CIM_ComputerSystem.
ElementName)
56
IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
Error A PCI fault has
been detected.
Error A PCI PERR has
occurred.
(Sensor = PCIs)
1. Check the PCI LED.
2. Reseat the affected adapters and
riser cards.
3. Update the server firmware (UEFI
and IMM2) and adapter firmware.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code
is supported for the cluster solution
before you update the code.
4. Remove both adapters.
5. Replace the riser cards.
6. (Trained technicians only) Replace
the system board (see "Removing
the system board" on page 258
and "Installing the system board"
on page 261).
1. Check the PCI LED.
2. Reseat the affected adapters and
riser cards.
3. Update the server firmware (UEFI
and IMM2) and adapter firmware.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code
is supported for the cluster solution
before you update the code.
4. Replace the adapters.
5. Replace the riser cards.