16. Position the rear adapter retention bracket so that the hole in one of the hinge
17. Rotate the rear adapter retention bracket into place so that the hole in the
18. Connect any required cables to the adapter. Route the cables so that they do
19. Install the air duct.
20. Install the side cover (see "Installing the side cover" on page 167).
21. Stand the server back up in its vertical position.
180
IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
Adapter
points is aligned with the hinge pin on the chassis; then, place the hinge pin
through the hole on the chassis.
opposite hinge point snaps into place over the hinge pin on the chassis.
not block the flow of air from the system fan.