Removing The Rear System Fan - IBM System x3100 M4 Type 2582 Problem Determination And Service Manual

To install the replacement battery on the 5U server model with hot-swap power
supplies (Model name: 2582-F4x), complete the following steps. For 4U server
models with non-hot-swap power supplies, please see the above sub-section.
1. Follow any special handling and installation instructions that come with the
2. Insert the new battery:
3. Stand the server back up in its vertical position.
4. Install and lock the side cover (see "Installing the side cover" on page 167).
5. Reconnect the external cables and power cords; then, turn on the attached
6. Start the Configuration/Setup Utility program and reset the configuration:

Removing the rear system fan

This procedure applies only to 4U server models with non-hot-swap power supplies.
Attention:
v To ensure proper cooling and airflow, do not operate the server for more than 30
To remove the rear system fan on server models with non-hot-swap power supplies
(4U chassis), complete the following steps.
1. Turn off the server and all attached devices; then, disconnect all power cords
2. Carefully turn the server on its side so that it is lying flat, with the cover facing
3. Remove the side cover (see "Removing the side cover" on page 166).
4. Remove the air duct.
5. Remove any adapters that impede access to the fan and the fan connector on
6. Remove the system fan:
See "Using the Setup utility" on page 271 for details.
replacement battery.
a. Orient the battery so that the positive side faces up.
b. Tilt the battery and slide the battery into its socket
Positive (+) side
c. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
devices and turn on the server.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See "Using the Setup utility" on page 271 for details.
minutes with the side cover removed.
and external cables.
up.
Attention: Do not allow the server to fall over.
the system board (see "Removing a ServeRAID adapter" on page 176).
Chapter 5. Removing and replacing server components
211