Section 10: Engine Nacelle Installation - Hangar 9 B25J Mitchell ARF Assembly Manual

Section 10: Engine Nacelle Installation

Required Parts
1
/ x 1/4-inch (28mm x 4mm) dowel (4)
8
Required Tools and Adhesives
Step 1
Use a short 8-32 socket head bolt and 9/64-inch ball
driver to draw the two blind nuts up into the engine
nacelle mounting plate.
54
Step 2
Place the nacelle support plate over the holes in the
trailing edge of the wing and trace the outline of the plate
onto the wing.
Step 3
Use a sharp hobby knife to remove the covering where the
plate will be secured to the wing.