Table of Contents
Advertisement
Section 6: Glow Engine Installation
Step 7
Attach the engine to the engine mount using four
and four 4-40 locknuts. The included engine mount is
drilled for the Evolution 36NT.
Note: The distance from the rear of the
mount to the front edge of the drive washer
3
will be 4
/
-inch (107mm). Using an
16
engine other than the Evolution engine
may required drilling new holes in the
mount for the engine mounting screws.
Step 8
arm.
32
Step 9
Slide the pushrod into the pushrod tube. Secure the
engine mount to the firewall using four 8-32 x 1
wire slightly so it moves freely inside the pushrod tube
and will clear the muffler.
Step 10
Use a pin drill and 5/64-inch (2mm) drill bit to enlarge the
hole in the throttle servo arm.
1
/
-inch
4
Hide quick links:
Advertisement
Table of Contents
