Step 4
Position the servo between the servo mounting
blocks. Make sure the servo is not resting on the
servo cover, which will transfer vibrations to the servo.
Use a felt-tipped pen to mark the locations for the servo
mounting screws.
Step 5
Use a drill and 1/16-inch (1.5mm) drill bit to drill the four
holes for the servo mounting screws.
Section 2: Aileron Servo Installation
Step 6
Apply a few drops of thin CA into each of the holes to
harden the surrounding wood to provide a stronger
surface for the screws to bite into.
Step 7
Mount the servo to the blocks using the hardware
provided with the servo.
15