Retract Air Line Routing Diagram - Hangar 9 B25J Mitchell ARF Assembly Manual

Retract Air line Routing Diagram

Retaining nuts are optional
3 GEAR
INSTALLATION
Right Landing
Gear Cylinder
Nose
Gear
Cylinder
Control
Valve
** USE THE PROPER LINK ROD ASSEMBLY
FOR THE CONTROL VALVE
(servo, servo arm, and link rod assembly are NOT
included in kit)
74
Tee
Fittings
1/ 4" Travel
Maximum
Servo
Arm
Link Rod
Assembly
roba rt roba rt
Optional On-board
Pressure Gauge #173
(NOT INCLUDED)
Included in the
VRX Kits
Fill Valve
Left Landing
Gear Cylinder
Note: The link rod between
the servo arm and the control
Servo
valve spool is very important.
Use a nylon clevis at the valve
the servo arm as shown. The
throw on the servo arm should
allow for approximately 1/4-inch
(4mm) of travel. This will keep
any excessive side loads on the
valve spool minimal and, in turn,
prevent any leakage around the
valve spool seals.
Fill Chuck
(AIR SUPPLY IN)