Table of Contents
Advertisement
Step 9
Slide the steering arm onto the nose gear wire. Next,
slide the mount on the wire, then a wheel collar. The
steering arm and wheel collar have setscrews that will
tighten onto the flat areas that have been pre-ground on
the nose gear wire.
Note: Make sure to use threadlock on the
setscrews for the steering arm and wheel collar.
Step 10
Install the rigging coupler in the steering arm as shown.
Section 7: Fixed Landing Gear Installation
Step 11
Prepare four 3mm x 25mm machine screws by sliding a
3mm washer on each screw. Slide the screws through the
nose gear mount, then slide the tapered block onto the
screws. The wider section of the block will be away from
the steering arm. This tapered block creates the forward
105-degree rake of the nose gear.
Step 12
Position the nose gear assembly in the fuselage and use
four 3mm washers and 3mm nuts to secure the nose gear
in the fuselage.
41
Hide quick links:
Advertisement
Table of Contents
