Section 12: Rudder And Servo Installation - Hangar 9 B25J Mitchell ARF Assembly Manual

Section 12: Rudder and Servo Installation

Required Parts
Required Tools and Adhesives
Step 1
Mounting the rudder servo follows the same procedure
as mounting the aileron servo (Section 2: Aileron Servo
Installation, Steps 1 through 7.) Use a 180 degree servo
arm and remove the excess arm using side cutters. Simply
follow those steps to mount the rudder servo to the rudder
servo cover.
Step 2
Route the servo lead to the nearest hole in the center of
the stabilizer using the installed string. Position the cover
so the servo arm is toward the tip of the stabilizer.
Step 3
Use a drill and 1/16-inch (1.5mm) drill bit to drill four
holes, approximately 1/8-inch (3mm) from the corners of
the servo cover.
Step 4
Apply a few drops of thin CA to each of the holes to
harden the surrounding wood.
59