Section 2: Aileron Servo Installation - Hangar 9 B25J Mitchell ARF Assembly Manual

Section 2: Aileron Servo Installation

Required Parts
1
/ x 1/4-inch (28mm x 6mm) dowel
8
1
/ x 5/16-inch (28mm x 8mm) dowel (2)
8
Required Tools and Adhesives
Step 1
Remove the servo cover from the wing. Use a sharp hobby
knife to remove the covering from the opening in the cover
so the servo arm can extend outside the cover.
14
Step 2
Position the aileron servo on the cover with the servo arm
centered in the opening. Use a pencil to mark the cover
where the flap servo is positioned.
Step 3
Use 30-minute epoxy to glue the servo mounting
blocks to the servo cover. Allow the epoxy to fully
cure before proceeding.