Section 6: Glow Engine Installation - Hangar 9 B25J Mitchell ARF Assembly Manual

Section 6: Glow Engine Installation

Required Parts
1
/ -inch socket head screw (8)
4
1
Required Tools and Adhesives
7/32-inch (5.5mm)
30
/ -inch (241mm) (2)
2
Step 1
Tape the appropriate template to the front of the engine
nacelle. Use a drill and a 1/16-inch (1.5mm) drill bit to
drill the four locations for the motor mount blind nuts.
and also drill the hole for the throttle pushrod. The throttle
pushrod hole is included on the engine template.
Step 2
Enlarge the holes for the motor standoff screws using a
drill and 7/32-inch (4mm) drill bit.