Step 17
Hold the aileron so it is aligned in the centered position.
With the servo centered, use a felt-tipped pen to mark
where the pushrod crosses the servo arm.
Step 18
Bend the pushrod wire 90 degrees at the mark made in
the previous step. Use a pushrod connector to secure the
pushrod to the servo arm. Use side cutters to remove any
excess wire extending beyond the connector.
Section 2: Aileron Servo Installation
Step 19
Use 30-minute epoxy to glue the 1
(28mm x 8mm) wing dowel in the wing. Press the
dowel into the wing and clean any excess epoxy from
the dowel and wing.
Step 20
Repeat Steps 1 though 19 for the remaining wing panel.
Step 21
Use 30-minute epoxy to glue the 1
(28mm x 6mm) wing dowel in the wing. Press the
dowel into the wing and clean any excess epoxy from
the dowel and wing.
1
/
x 5/16-inch
8
1
/
x 1/4-inch
8
19