Table of Contents
Advertisement
Section 8: Retractable Landing Gear Installation
Step 14
Center the nose gear and steering servo. Thread a clevis
on the threaded rigging couplers and attach them to the
steering servo arm. Make sure to cut a 1/4-inch (4mm)
piece of heat shrink tubing for each of the clevises and
slide them into position. Mark where the cable crosses the
hole in the fastener.
Step 15
Repeat the crimping process, aligning the marks made
on the cable with the hole in the fastener. Cut any excess
cable using side cutters.
48
Step 16
Use a rotary tool and sanding drum to remove the area
of the nose gear cover to allow the nose wheel strut and
wheel to pass through.
Note: Use the same color air line for
up and then use the same other color
for down on each of the three retract
units. This will allow you to follow the
included air line diagram from Robart.
Note: Use threadlock on all screws to keep
them from coming loose during flight.
Hide quick links:
Advertisement
Table of Contents
