Hangar 9 B25J Mitchell ARF Assembly Manual page 57

Section 10: Engine Nacelle Installation
Step 8
Attach the engine nacelle to the wing using two 8-32 x
Note: Use threadlock on all screws to keep
them from coming loose during flight.
Step 9
Position the nacelle top cover on the wing, aligning it with
the front and rear of the engine nacelle. Trace the outline
of the nacelle top cover on the wing with a felt-tipped pen.
56
Step 10
Use a sharp hobby knife to remove a 1/8-inch (3mm) wide
strip to the inside of the line drawn in the previous step.
Step 11
Use 30-minute epoxy to glue the nacelle top cover to
the wing. Use tape to hold the nacelle cover while the
epoxy cures.
Step 12
Repeat Steps 1 through 11 to install the remaining engine
nacelle and nacelle top cover on the wing.