Section 3A: Two-Stroke Engine Installation - Hangar 9 Tango 40 ARF Assembly Manual

 
Step 8
Install the pre-assembled 4
linkage. With the radio on, adjust the length of the linkage
so the rudder is centered.

Section 3A: Two-Stroke Engine Installation

Required Parts
• Fuselage
•#6 washer (4)
• 6-32 locknut (4)
• 4-40 x 1/2-inch socket head screw
• 6-32 x 1-inch machine screw (8)
• 15-inch (380mm) throttle pushrod
1
• 2 / -inch (64mm) spinner w/hardware
2
• Pushrod connector backplate
• 3mm x 5mm machine screw
• Plywood radio tray (glow)
Required Tools and Adhesives
• Servo w/hardware
• Drill
• Hex wrench: 3/32-inch
• Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm),
9/64-inch (4mm)
1
/ -inch (114mm) rudder
2
• Engine mount (2)
• Pushrod connector
• #4 washer
• Ruler
• Phillips screwdriver
• Hobby knife
Section 2: Landing Gear and Tail Installation

Step 9
Repeat Steps 6 through 8 to install the elevator servo
and linkage.

Step 1
Mount the engine mount onto the firewall using four
6-32 x 1-inch screws.
Note: Use the vertical holes for
mounting the engine mount.
Note: Use threadlock on the screws to
prevent them from vibrating loose in flight.
13