Section 5: Electric Motor Installation
Step 8
Use hobby scissors and a rotary tool with a small sanding
drum to make a round opening in the dummy engine for
the motor shaft.
Step 9
Use a sharp hobby knife to remove the material between
the dummy cylinder heads to allow cooling air to pass
through the dummy engine and over the motor.
28
Step 10
Use 30-minute epoxy to glue the dummy engine inside
the cowling.
Step 11
Tape four pieces of card stock to the engine nacelle. Align
the card stock so the ends align with the front edge of
the firewall. Align the sides of the card stock so they are
centered on the raised areas of the nacelle.