Step 12
Cut two 1/4-inch (4mm) long pieces from the heat
shrink tubing and slide it onto each of the clevises.
Thread a nylon clevis onto the 6-inch (152mm) aileron
pushrod wire.
Section 2: Aileron Servo Installation
Step 13
Remove the backplate from a control horn. Connect the
clevis to the horn and position the horn so the pushrod
is parallel to the servo horn. Align the holes in the horn
with the hinge line. Use a felt-tipped pen to transfer the
locations for the mounting screws on the aileron.
Align holes
with hinge line
17