Table of Contents
Advertisement
Step 4
Use 30-minute epoxy to glue the plate on the wing.
Step 5
Use 30-minute epoxy to glue the two 1
(28mm x 4mm) dowels into the hole in the leading edge
of the wing for the engine nacelle.
Secure a 12-inch (305mm) servo extension to the throttle
(or speed control) lead. Tie the string around the end of
the extension as shown.
1
/
x 1/4-inch
8
Carefully pull the servo extensions through the wing using
the string. The engine nacelle will need to be close to
the wing for the extension from the throttle servo (speed
control) to reach the opening in the wing. Once the
extensions have been pulled through the wing, use tape to
keep them from falling back into the wing.
Section 10: Engine Nacelle Installation
Step 6
Note: If you have installed retracts,
you will need to tie the string to the
air lines as well in this step.
Step 7
55
Hide quick links:
Advertisement
Table of Contents
