Table of Contents
Advertisement
Section 8: Retractable Landing Gear Installation
Step 21
From the back side of the mounting rails, insert the
four 4-40 blind nuts and use a 4-40 bolt with a washer
to draw each blind nut into each one of the four holes
just drilled.
Step 22
Install 20-inch (508mm) of each color of air line onto
each air cylinder inlet on the main landing gear. These air
lines will be pulled later through the same holes in the
wing that the throttle servo leads are pulled through. Be
certain to follow the included Robart air line diagram for
the correct hook-up of the colored air lines.
50
Step 23
Set the main gear retract onto the mounting rails. Place
head bolts, then securely fasten the retract to the mounting
rails with these four 4-40 x 1-inch bolts.
Hide quick links:
Advertisement
Table of Contents
