Section 13: Tail Section Installation
Step 8
Mix up 1/2-ounce (15Ml) of 30-minute epoxy. Apply the
epoxy to the exposed wood of the stabilizer. The stabilizer
should then be bolted into place. Refer to Step 4 for
details Use paper towels and rubbing alcohol to remove
any excess epoxy from the fuselage and stabilizer. Allow
the epoxy to fully cure before proceeding.
Step 9
Position the servo in the opening with the servo arm
facing the front of the fuselage. Mark the locations for the
servo mounting screws using a felt-tipped pen.
66
Step 10
Use a drill and 1/16-inch (1.5mm) drill bit to drill the
locations for the servo mounting screws.
Step 11
Apply a few drops of thin CA to each of the holes drilled
in the previous step. This will help harden the wood,
making the screws more secure in their placement.