Section 5: Electric Motor Installation
Required Parts
3
/
-inch (45mm) motor standoff (2)
4
Required Tools and Adhesives
Step 1
Tape the appropriate template to the front of the engine
nacelle. Use a drill and a 1/16-inch (1.5mm) drill bit to
drill the four locations for the motor standoffs.
26
Step 2
Enlarge the holes for the motor standoff screws using a
drill and 5/32-inch (4mm) drill bit.
Step 3
Use a drill and a 5/32-inch (4mm) drill bit to enlarge the