Section 6A - Engine Installation: Saito 1.00 - Hangar 9 showtime 4d 90 Assembly Manual

Section 6A – Engine Installation: Saito 1.00
Required Parts
• Fuselage
• 8-32 x 1" screw (4)
• #8 washer (12)
• 8-32 x 1 1 / " screw (4)
4
• Nylon clevis
• 17" throttle pushrod tube
Required Tools and Adhesives
• Medium CA
• Drill
• Square
• Foam: 1/4"
• Threadlock

Step 1
Locate the two engine mount halves. Attach them to the
firewall using four 8-32 x 1" screws and four #8 washers.
Use threadlock on the screw to prevent it from
coming loose in flight.
 Step 2
Place the engine onto the engine mount. Position the
engine so the drive washer is 5
• Engine mount (2)
• 8-32 locknut (4)
• Fuel tank assembly
• 13" tie wrap (2)
• 1/4" fuel tubing
• Ruler
• Drill bit: 11/64"
• Hobby knife
• Felt-tipped pen
3 / " from the firewall.
4
 Step 3
Transfer the location of the holes on the engine mounting
lugs onto the engine mount.

Step 4
Use a drill and 11/64" drill bit to drill the locations for the
engine mounting bolts.
Note: It is best to use a drill press for drilling
the holes in the engine mounts.
17