Section 6: Glow Engine Installation
Step 16
Apply a few drops of thin CA into each hole to harden the
surrounding wood. You may need to run the drill bit back
through the holes after applying the CA.
Step 17
Mount the servo in the engine nacelle as shown.
34
Step 18
Electronically move the throttle servo to low, and
physically close the carburetor. Secure the position of
the wire using a 2mm setscrew and the included 1.5mm
hex wrench.
Note: Use threadlock on the setscrew
to prevent it from vibrating loose.
Step 19
Use side cutters to trim the pushrod wire so only 1/2-inch
(12mm) extends beyond the rear of the pushrod connector.