2-Stroke Glow Engine Installation - Hangar 9 Funtana 125 Assembly Manual

2-Stroke Glow Engine Installation

Required Parts
Fuselage assembly Pushrod connector
2mm washer 2mm knurled nut
4mm locknut (4) 4mm washer (8)
Throttle pushrod tube, 16 / -inch (420mm)
1
2
Throttle pushrod wire, 19 / -inch (492mm)
3
8
4mm x 25mm hex head bolt (4)
4mm x 30mm hex head bolt (4)
Engine mount rail (right and left)
Tools and Adhesives
Pencil Drill
Hex wrench: 2.5mm, 3mm Nut driver: 7mm
Threadlock Pin vise
Phillips screwdriver: #1 Felt-tipped pen
Ruler
Drill bit: 1/16-inch (1.5mm), 9/64-inch (3.5mm),
5/32-inch (4mm)

Step 1
Locate the items necessary to install the engine included
with your model.
Hangar 9 Funtana 125 ARF Assembly Manual

Step 2
Use four 4mm x 25mm hex head bolts and four 4mm
washers to attach the engine mount rails to the firewall.
Tighten the screws using a 3mm hex wrench after applying
threadlock to each of the screws.

Step 3
Position the engine so the drive washer is 5
forward of the firewall.

Step 4
Use a pencil to transfer the locations for the engine
mounting bolts to the engine mount rails.

Step 5
Use a pencil to mark the location for the throttle pushrod
tube.
/ -inch (133mm)
1
4
27