Configuring Network Settings - Cisco TelePresence 7010 Help Manual

Network settings

Configuring network settings

To configure the network settings on the TelePresence Server and check the network status, go to
Network > Network settings.
On this page:
IP configuration settings
n
IP status
n
Ethernet configuration
n
Ethernet status
n
IP configuration settings
These settings determine the IP configuration for the appropriate Ethernet port of the TelePresence Server.
When you have finished, click Update IP configuration.
Table 9: IPv4 configuration
Field Field description
IP Specifies whether the port should be
configuration configured manually or automatically. If set to
Automatic via DHCP the TelePresence
Server obtains its own IP address for this port
automatically via DHCP (Dynamic Host
Configuration Protocol). If set to Manual the
TelePresence Server will use the values that
you specify in the Manual configuration fields
below.
IP address The dot-separated IPv4 address for this port,
for example 192.168.4.45.
Subnet mask The subnet mask required for the IP address
you wish to use, for example 255.255.255.0
Default The IP address of the default gateway on this
gateway subnet, for example 192.168.4.1
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
Usage tips
You can disable IPv4 on the TelePresence
Server port but only if logged in using IPv6.
You only need to specify this option if you have
chosen Manual IP configuration, as described
above.
For Port A, if the IP configuration setting is set
to Automatic by DHCP this setting will be
ignored.
Page 16 of 132