Cisco TelePresence 7010 Help Manual page 88

Endpoints and endpoint groups
Table 45: Initial status (continued)
Field Field Usage tips
description
Video Whether the If set to Muted, when the endpoint or endpoint group joins a conference, the participant
to initial video using this endpoint or endpoint group will but not see the other participants, but will be
to the seen themselves. This can be altered during the course of the conference either in the
endpoint or endpoint's or endpoint group's status page, or from the relevant conference's status
endpoint page.
group is
either Active
or Muted.
Table 46: Display parameters
Field Field description
Display Clear the checkbox if you want to enable the grayed-
parameters out display parameters.
Full screen This option controls the conditions under which this
view endpoint will be displayed full screen.
Select a setting from the drop-down list:
Allowed: The stream from a single-camera
n
endpoint is allowed to display in a full screen pane
when the conference is viewed on a multi-screen
endpoint.
Dynamic: As for Allowed if there are no grouped
n
endpoints to display on the multi-screen endpoint.
When there are grouped endpoints to show on
the multi-screen endpoint, the stream from a
single-camera endpoint will be restricted to
displaying as a smaller, continuous presence
pane.
Disabled: The stream from a single-camera
n
endpoint will never be shown as a full screen pane
on a multi-screen endpoint.
Show Select this option to show borders around
borders participants displayed in the conference view on this
around endpoint or endpoint group.
endpoints
Active Select this option to show a red border around the
speaker active speaker on this endpoint or endpoint group.
display
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
Usage tips
The checkbox is checked by default, which
means the endpoint uses the
TelePresence Server's default endpoint
display parameters (on Configuration >
Default endpoint settings).
After clearing the box, any changes you
make to the display parameters will apply
to this endpoint only.
This option is only available for single-
camera endpoints.
We recommend using the default setting,
which is Allowed.
For more information, see Understanding
how participants display in layout
This setting is only available if Show
borders around endpoints is selected.
views.
Page 88 of 132