Cisco TelePresence 7010 Help Manual page 45

Configuration
Table 28: Default advanced endpoint settings (continued)
Field Field description
Transmitted This setting is for transmitted video
video resolutions resolutions from the TelePresence Server to
an endpoint or endpoint group.
Select a setting from the drop-down list to
set as the default :
4:3 resolutions only
n
16:9 resolutions only
n
Allow all resolutions
n
Motion/sharpness This setting controls the preference for
tradeoff which resolutions the TelePresence Server
will transmit to the endpoint for motion
(frames per second) and sharpness (frame
size or resolution). The setting controls how
the TelePresence Server will determine its
preference of the settings to be used.
Select a setting from the drop-down list to be
used as the default:
Favor motion: the TelePresence Server
n
will try and use a high frame rate. That is,
the TelePresence Server will strongly
favor a resolution of at least 25 frames per
second
Balanced: the TelePresence Server will
n
select settings that balance resolution and
frame rate (where the frame rate will not
be less than 12 frames per second)
Favor sharpness: the TelePresence
n
Server will use the highest resolution that
is appropriate for what is being viewed
Default bandwidth The maximum network capacity used by the
(both to and from media channels established by the
the server) TelePresence Server to unknown endpoints
and to new pre-configured endpoints for
which a value has not been set.
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
Usage tips
Endpoints advertise the resolutions that they
are able to display. The TelePresence
Server then chooses the resolution that it will
use to transmit video from those advertised
resolutions. However, some endpoints do
not display widescreen resolutions optimally.
Therefore, you might want to use this setting
to restrict the resolutions available to the
TelePresence Server for transmissions to
this endpoint or endpoint group.
(4:3 and 16:9 are the preferred options—
avoid using Allow all resolutions if possible.)
The default is 16:9 resolutions only.
The default is Balanced.
When the TelePresence Server makes a call
to an endpoint, it chooses the maximum
bandwidth that is allowed to be used for the
media channels which comprise that call.
This field sets that maximum bandwidth, and
is the total bandwidth of the audio, video,
and content channels combined. For
endpoint groups, this is the maximum
bandwidth per endpoint.
The bandwidth available may also be limited
by the configuration of the endpoint or other
devices through which the call passes.
The default is 4.00 Mbit/s.
Page 45 of 132