Ethernet Status - Cisco TelePresence 7010 Help Manual

Network settings
Table 11: Ethernet configuration
Field Field description
Ethernet Select Automatic or Manual.
settings
If you select Manual, you must also supply the
speed and duplex settings. Select Automatic
if you want this Ethernet port to automatically
negotiate its Ethernet settings with the
connected device.
Speed (For Manual configuration only) Set the
connection's speed to 10 Mbit/s or 100 Mbit/s.
Duplex (For Manual configuration only) Set the
connection's duplex mode to Full duplex or
Half duplex.

Ethernet status

Table 12: Ethernet status
Field Field description
Link status Indicates whether or not this Ethernet link is
connected.
Speed The speed (10/100/1000 Mbit/s) of this
Ethernet link.
Duplex The duplex mode (Full duplex or Half duplex)
of the network connection to this port.
MAC address The fixed hardware MAC (Media Access
Control) address of this port.
Packets sent The total number of packets sent from this
port (all TCP and UDP traffic).
Packets The total number of packets received by this
received port (all TCP and UDP traffic).
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
Usage tips
It is important that the devices at either end of
the Ethernet connection have the same
settings. That is, configure both devices to use
automatic negotiation, or configure them both
with the same fixed speed and duplex settings.
Select Automatic negotiation if you require a
connection speed of 1000 Mbit/s.
The connection speed setting must be the
same for the ports at both ends of this
connection.
The connection duplex setting must be the
same for the ports at both ends of this
connection.
Full duplex mode allows simultaneous
bidirectional transmission, while half duplex
mode only allows bidirectional transmission
that is not simultaneous.
Usage tips
This value is negotiated with the device to
which this port is connected or based on your
manual configuration.
This value is negotiated with the device to
which this port is connected or based on your
Manual configuration selected above.
This value can not be changed, it is for
information only.
This information can help you confirm that the
TelePresence Server is transmitting packets
into the network.
This information can help you confirm that the
TelePresence Server is receiving packets from
the network.
Page 18 of 132