Configuring H.323 Settings - Cisco TelePresence 7010 Help Manual

Configuration

Configuring H.323 settings

The H.323 settings page allows you to enable the TelePresence Server to use an H.323 gatekeeper.
To access this information, go to
To update the defaults, or change the configuration at any time, edit the fields referring to the table below for
details and click Apply changes.
Table 24: H.323 gatekeeper
Field Field description
Use Enables the TelePresence Server to register
gatekeeper numeric IDs for its conferences with an H.323
gatekeeper.
Check the box to enable this feature.
Address The network address of the gatekeeper to
which TelePresence Server registrations
should be made.
H.323 ID to Specifies a server-wide identifier that the
register TelePresence Server can use to register itself
with the H.323 gatekeeper.
Password If the configured gatekeeper requires
password authentication from registrants,
enter the password.
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
Configuration > H.323 settings.
Usage tips
When disabled, no gatekeeper registrations
are attempted (and existing registrations are
removed), regardless of other gatekeeper or
per-conference settings.
When enabled, registrations with the
gatekeeper are attempted, and the gatekeeper
is contacted for incoming and outgoing calls. If
the gatekeeper does not respond, calls are still
connected if possible.
Can be specified either as a host name or as
an IP address.
This field will have no effect if Use gatekeeper
is disabled.
The TelePresence Server must make a server-
wide registration before it can register any IDs
with the H.323 gatekeeper.
This field is required for the gatekeeper
registration, but has no effect if Use
gatekeeper is disabled.
The password is used, in association with the
H.323 ID to register as the username, to
authenticate the TelePresence Server to the
gatekeeper (only if the gatekeeper is
configured to require authentication).
Page 37 of 132