Calling Participants To Join A Conference - Cisco TelePresence 7010 Help Manual

Conferences

Calling participants to join a conference

1. Go to the Conference > Conference name > Status
2. Click Call endpoint if you want to invite one or more participants to join.
3. The Call endpoint page displays.
Here you can call endpoints that the TelePresence Server knows about as well as unknown endpoints.
Call known endpoints
The Endpoints list contains all the endpoints that are known to the TelePresence Server. This list may span
more than one page, in which case there are links to all the pages near the bottom of each page.
1. Select the endpoints you want to call by checking the boxes next to the endpoint names.
You can select all or clear all by checking the box in the heading row.
2. Click Call selected.
Call an unknown endpoint
If an endpoint you want to invite is not in the Endpoints list:
1. Enter its IP address, URI, or E.164 number in the Address field.
2. Select the Call protocol to use. (The default call out protocol is SIP.)
3. Check Call direct if necessary.
You will have to enter the full IP address if you check this option. You should only need to do this if the
endpoint is not registered with either the gatekeeper or registrar.
4. Select the Bandwidth you want to allow for this call, from 64 kbps up to 6 Mbps.
5. Enter a Send DTMF sequence if necessary.
This is usually unnecessary. However, a DTMF sequence may be required by the endpoint, for example a
numeric PIN, if so, enter the keypress sequence here.
6. Click Call endpoint.
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
page.
Page 73 of 132