Detaching And Refitting The Heat Roller - Kyocera KM-3050 Service Manual

2GN/2GP/2GR

(5) Detaching and refitting the heat roller

Follow the procedure below to replace the heat roller.
Procedure
1. Remove the fuser unit (see page 1-5-28).
2. Remove the upper fuser cover (see page 1-
5-29).
3. Remove the press roller and fuser heater
(see page 1-5-30 and 31).
4. Remove the fuser gear.
5. Remove the heat roller from the fuser unit.
Remove the C ring, gear, bearing and bush-
ing on the rear side of the heat roller and
remove the C ring, ground plate, bearing
and bushing on the front side.
6. Replace the heat roller and install the roller
to fuser unit.
7. Refit the fuser gear.
8. Refit the fuser heater, press roller and upper
fuser cover.
9. Refit the fuser unit.
1-5-32
Bearing
Ground plate
Bushing
C ring
Fuser gear
Figure 1-5-65
Heat roller
Figure 1-5-66
C ring
Bushing
Gear
Bearing