Remove the tapes, spacers and pad.
1. Remove two tapes.
2. Pull the lever and operation section is low-
ered.
3. Remove two spacers.
Remove waste textile on the operation
panel, if any.
4. Remove the pad.
5. Remove the tape holding the power cord.
Install the optional paper feeder.
1. Install the optional paper feeder as necessary
2. Verify levelness at the four corners of the platen using a level gauge, and
adjust the level bolts at the bottom of the machine to optimize levelness.
Release the lever holding mirror 1 and 2 frames.
1. Turn the lever of the machine rear side with
the tool to release the lever holding the mir-
ror 1 and 2 frames.
Spacers
Tape
Figure 1-2-4
Lever
Figure 1-2-5
2GN/2GP/2GR
Pad
Tape
1-2-5