Kyocera KM-3050 Service Manual page 27

Install the fixing brackets.
1. Remove two screws from the rear cover.
2. Hook the catch of fixing bracket onto the
groove of round frame, and secure it using
two screws removed before step.
Carry out initial developer setting (maintenance item U130).
1. Turn the main power switch on and press the status key.
2. Enter the maintenance mode by entering 10871087 using the numeric keys.
3. Enter 130 using the numeric keys and press the start key.
4. Press the start key to execute the maintenance item. The drive stops within approximately 5 minutes.
5. Press the stop key.
Output an own-status report (maintenance item U000).
1. Enter 000 using the numeric keys and press the start key.
2. Select MAINTENANCE and press the start key to output a list of the current settings of the maintenance items.
3. Press the stop key.
Exit maintenance mode.
1. Enter 001 using the numeric keys and press the start key. The machine exits the maintenance mode.
Print out the user setting list.
1. Select [Report Print] to output the user various setting reports.
Make test copies.
1. Place an original and make test copies.
Attaching the language label (230 V specifications only).
1. According to need, attach the correspond language label.
Completion of the machine installation.
Grooves
Fixing brackets
Figure 1-2-14
2GN/2GP/2GR
1-2-9