Kyocera KM-3050 Service Manual page 119

Section Description
Optional 75
DP An original jam in the
original registration
section
76
An original jam in the
original feed/conveying
section
78
Document processor
top cover open
Optional 80
finisher Jam between the fin-
isher and machine
(3000-sheet document
finisher only)
81
Paper entry sensor
nonarrival jam
82
Jam in stapler
Conditions
The original registration switch (ORSW) does not turn off
within specified time.
DP timing switch 1 (DPTSW1) does not turn on within
specified time.
DP timing switch 2 (DPTSW2) does not turn on within
specified time.
The document processor top cover is opened during orig-
inal feeding.
Paper ejection is not output from the machine to the doc-
ument finisher within specified time of the paper entry
sensor (PES) turning on.
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned off even if a
specified time has elapsed after the machine eject signal
was received.
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
(3000-sheet document finisher)
The paper entry sensor (PES) does not turn off within
specified time of its turning on.
(Document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
(Built-in finisher)
The paper conveying switch (PCSW) is not turned on
even if a specified time has elapsed after the machine
eject signal was received.
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is con-
veyed to the intermediate tray from the paper conveying
unit.
(3000-sheet document finisher)
The home position is not detected within the specified
time when driving the staple motor.
(Document finisher)
The staple home position sensor (STSPS) is not turned
on within the specified time when driving the staple motor
(STM).
(Built-in finisher)
The staple home position sensor (STHPS) is not turned
on within the specified time when driving the staple motor
(STM).
2GN/2GP/2GR
Specified time
19533 pulse
4979 pulse
2500 pulse
-
15 s
1360 ms (30 ppm)/
1052 ms (40/50 ppm)
1360 ms (30 ppm)/
1052 ms (40/50 ppm)
2989 ms (30 ppm)/
2313 ms (40/50 ppm)
2627 ms
1573 ms (30 ppm)
1217 ms (40/50 ppm)
Paper length + 1123
ms (30 ppm)
Paper length + 869
ms (40/50 ppm)
600 ms
1000 ms
600 ms
1-4-7