Other Electrical Components - Kyocera KM-3050 Service Manual

(4) Other electrical components

12
10
15
14
9
4
5
1. Upper paper feed clutch 1 (PFCL-U) ........... Primary paper feed from the cassette 1.
2. Lower paper feed clutch 2 (PFCL-L) ............ Primary paper feed from the cassette 2.
3. Feed clutch 1 (FCL1) ................................... Controls the drive of feed roller.
4. Feed clutch 2 (FCL2) ................................... Controls the drive of feed roller.
5. Feed clutch 3 (FCL3) ................................... Controls the drive of feed roller.
6. MP paper feed clutch (MPPFCL) ................. Primary paper feed from the MP tray.
7. MP feed clutch (MPFCL).............................. Controls the drive of MP feed roller.
8. Registration clutch (RCL)............................. Secondary paper feed.
9. Duplex feed clutch (DUPFCL)...................... Controls the drive of the duplex feed roller.
10. Feedshift solenoid (FSSOL)......................... Operates the feedshift guide.
11. Toner feed solenoid (TNFSOL) .................... Replenishes toner.
12. Exposure lamp (EL) ..................................... Exposes originals.
13. Cleaning lamp (CL) ...................................... Removes residual charge from the drum surface.
14. Fuser heater M (FH-M) ................................ Heats the heat roller.
15. Fuser heater S (FH-S) ................................. Heats the heat roller.
16. Fuser unit thermostat 1 (FTS1) .................... Prevents overheating in the fuser section.
17. Fuser unit thermostat 2 (FTS2) .................... Prevents overheating in the fuser section.
18. Hard disk unit (HDD).................................... Storages the image data and information of job accounting mode.
19. Cassette heater (CH) ................................... Dehumidifies the cassette section.
16,17
11
13
8
3
1
2
Figure 2-2-4 Other electrical components
18
7
6
19
2GN/2GP/2GR
Machine front
Machine inside
Machine rear
2-2-5