2K5
(2) Detaching and refitting the heat roller separation claws
Follow the procedure below to replace the heat roller separation claws.
Procedure
1. Remove the fuser heater (see page 1-5-43).
2. Remove four screws.
3. Unhook four hooks and remove the rear
fuser guide.
4. Remove the spring and remove the heat
roller separation claws.
5. Replace the heat roller separation claws and
install the claws.
6. Refit all the removed parts.
1-5-40
Rear fuser guide
Hook
Hook
Screw
Heat roller
separation claw
Spring
Hook
Screw
Screw
Figure 1-5-74
Figure 1-5-75
Hook
Screw