Removing A Dimm - HP Z600 Maintenance And Service Manual

Removing a DIMM

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
CAUTION:
workstation and unplug the power cord from the AC power outlet. If you do not unplug the power
cord before installing memory, the modules might be damaged and the workstation will not
recognize the memory changes.
3. Remove the memory fan (see
4. Remove the rear system fan assembly (see
on page
5. Push gently outward on the DIMM socket levers
Figure 5-70
6. Lift the DIMM straight up and out of the socket
126 Chapter 5 Replacing components
To ensure that DIMMs are not damaged during removal or installation, power off the
Removing the memory fan on page
122).
Removing a DIMM
Predisassembly procedures on page
Removing the side access panel on page
Removing the rear system fan assembly
as shown in the following figure.
, then store the DIMM in an antistatic bag.
2
73).
75).
122).
ENWW