Figure 4-28
Front PCI card guide and fan removal (optional)
NOTE
length add-in cards.
1.
Disconnect power from the system
access panel
on page
2.
Disconnect the fan wire 1 from the connector on the system board.
3.
Release the two card guide latches 2 (only one illustrated). Pivot the card guide toward the system
board 3, and lift it out of the chassis 4.
Figure 4-29
ENWW
Installing the PCI Express card
The fan is only used for special configurations, but the card guide is used with all full-
(Side access panel on page
64).
Removing the front fan
(Predisassembly procedures on page
63), and remove the front bezel
Removal and replacement of components
57), remove the side
(Front Bezel
81