Download  Print this page

Installing A Hard Drive In The Fifth Hard Drive Bay - HP Xw8400 - Workstation - 4 GB RAM User Manual

Hp xw8400 service and technical reference guide.
Hide thumbs

Advertisement

6.
For a SAS hard drive, attach a SAS/SATA adapter to the connector on the hard drive. Attach a
data cable from a SAS connector on the system board to the hard drive, and attach a power cable
to the drive.
Figure 4-40

Installing a hard drive In the fifth hard drive bay

To install a hard drive into fifth HDD bay:
1.
Place the workstation on its side, and remove the three drive screws that are located on the bottom
of the chassis.
Figure 4-41
2.
Insert the drive into bay 5, and align the holes in the bottom of the hard drive with the screw holes
at the base of the chassis.
3.
Insert the screws through the base, and tighten them to secure the hard drive to the chassis.
ENWW
Installing the SAS/SATA adapter (left) and cable (right)
Installing screws for the hard drive in the fifth hard drive bay
Removing and replacing components
87

Advertisement

Table of Contents

   Related Manuals for HP Xw8400 - Workstation - 4 GB RAM

   Related Content for HP Xw8400 - Workstation - 4 GB RAM

Comments to this Manuals

Symbols: 0
Latest comments: