Installing A Hard Drive Into An Internal Drive Bay - HP 8200 Elite Series Maintenance And Service Manual

b. If your are installing a media card reader, connect the USB cable to the USB system board
connector labeled MEDIA.
Figure 6-21
8. If you are installing a new drive, connect the opposite end of the data cable to the appropriate
system board connector.
NOTE:
drive to the white SATA connector on the system board labeled SATA2. Connect the data cable
for a second optical drive to the white SATA connector on the system board labeled SATA3.
Refer to
connectors.
9. Replace the front bezel and computer access panel.
10. Reconnect the power cord and turn on the computer.
11. Lock any security devices that were disengaged when the computer access panel was removed.

Installing a Hard Drive into an Internal Drive Bay

NOTE: The system does not support Parallel ATA (PATA) hard drives.
Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
To install a hard drive in a 3.5-inch internal drive bay:
1. Prepare the computer for disassembly
2. Remove the computer access panel
Connecting the Media Card Reader USB Cable
If you are installing a new SATA optical drive, connect the data cable for the first optical
System Board Connections on page 78 for an illustration of the system board drive
(Preparation for Disassembly on page
(Computer Access Panel on page
73).
74).
Drives 95