Table of Contents
Advertisement
Replacing the control panel bridge card
To replace the control panel bridge card:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Replacing the system board
To replace the system board:
1
2
3
56
CHAPTER 4: Installing Components
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Follow the instructions in
Remove the fan duct and system fans by following the instructions in
44.
Remove the media cage by following the instructions in
drive" on page
33.
Disconnect the cables from the control panel bridge card.
Remove the top panel screw (1), then loosen the thumbscrew (2) holding the control panel
bridge card to the chassis.
Push the control panel bridge card (3) toward the front of the chassis and remove it, then
store it in a static-free bag.
Holding the new control panel bridge card by the edges, place it in the chassis, then slide
it toward the back of the chassis.
Tighten the thumbscrew to secure the control panel bridge card in the chassis.
Insert the media cage into the assembly bay in the chassis.
Secure the assembly by tightening the thumbscrew you previously loosened.
Connect the data and power cables to the back of the drives and the control panel bridge
card.
Reinstall the fan duct and system fans by following the instructions in
fans" on page 44.
Follow the instructions in
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Remove the PCI riser assembly by following the instructions in
expansion cards" on page
1
3
2
42.
30. Make sure
31.
"Replacing system
"Removing and installing an optical
"Replacing system
32.
30. Make sure
31.
"Installing and removing PCI
- Quick Links:
- Beep Codes
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
