Removing And Installing A Tape Drive - Gateway E-9525R User Manual

14
15
16
17
18
19

Removing and installing a tape drive

To remove and install a tape drive:
1
2
3
4
5
6
www.gateway.com
Secure the assembly by tightening the thumbscrew you previously loosened.
Attach the 44-pin optical drive cable to the back of the optical drive interface board.
Reinstall the large fan cage by following the instructions in
page 44.
Follow the instructions in
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
Reconnect all power cords and peripheral device cables, then turn on the server.
Caution
The tape drive is not hot-swappable. Before installing or removing the drive,
make sure that power is turned off and the power cord(s) is unplugged.
Follow the instructions in
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
Follow the instructions in
Remove the large fan cage by following the instructions in
page 44.
Disconnect the data and power cables from the tape drive.
Loosen the thumbscrew (1) holding the media cage in the chassis, then push the
assembly (2) out the front of the chassis.
"Closing the server case" on page
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Replacing system fans" on
32.
30. Make sure
31.
"Replacing system fans" on
35