Gateway E-9525R User Manual page 40

7
8
9
10
11
12
13
34
CHAPTER 4: Installing Components
Lift the locking tab (3) on the back of the optical drive tray, then push the optical drive (4)
and tray out of the bay.
Lift the optical drive (5), then pull it from the tray (6).
Unscrew the two screws (5) holding the optical drive interface board on the back of the
optical drive, then remove the interface board.
Using the two screws you just removed, attach the optical drive interface board to the back
of the new optical drive.
Align the optical drive with the two clips on the left side of the optical drive tray, then press
the optical drive into place in the tray.
Insert the optical drive tray into the bay in the media cage until it clicks into place.
Insert the media cage into the assembly bay in the chassis.