Gateway E-9525R User Manual page 42

7
8
9
10
11
12
13
14
15
16
17
36
CHAPTER 4: Installing Components
Lift the locking tab (3) on the back of the tape drive tray, then push the tape drive (4) and
tape drive bracket out of the tray.
Unscrew the four mounting screws (5) holding the tape drive in the tape drive bracket, then
lift the tape drive out of the bracket.
Put the new tape drive into the drive bracket and secure with the four screws you removed
previously (if you are installing a new tape drive, the screws and bracket are included with
the tape drive installation kit).
Push the new tape drive and drive bracket into the tape drive tray, then push down the
locking tab.
Insert the media cage into the assembly bay in the chassis.
Secure the assembly by tightening the thumbscrew you previously loosened.
Connect the data and power cables to the back of the tape drive.
Reinstall the large fan cage by following the instructions in
page 44.
Follow the instructions in
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
Reconnect all power cords and peripheral device cables, then turn on the server.
"Closing the server case" on page
"Replacing system fans" on
32.